What is covered in your NW Natural Tune Up
Mike's Heating and Air is a Preferred Contractor for new equipment sales and installation as well as a Service Solutions Contractor for repair and maintenance. We have met quality assurance standards established by NW Natural. We are licensed, bonded, insured, and recommended by NW NATURAL.
20 Point Gas Furnace Tune Up
- Cycle the furnace
- Limited blower cleaning
- Verify limit operations
- Measure and record delta T
- Clean flame sensor
- Cycle condensate pump (90% or better EF)
- Measure and record amp draw to the blower
- Rate/set furnace input
- Measure and record amp draw inducer
- Clean or change filter (customer supplied or purchased from the contractor)
- Inspect flue pipe
- Measure and verify ignition protocols
- Clean burners
- Tighten electrical connections
- Clean and adjust pilot assembly
- Clean exterior
- Measure and adjust gas pressure
- Brush and inspect heat exchanger
- Conduct a bubble test for gas leaks
- Vacuum burner compartment
11 Point A/C Tune Up
- Cycle the air conditioner
- Test total refrigerant pressure
- Test outdoor ambient temperature
- Test indoor ambient temperature test
- Test amperage draw on fan motors
- Oil motors
- Check integrity of electrical contractors
- Tighten electrical connections
- Check indoor coils (drain properly)
- Inspect and wash outdoor coils
- Change fuses
17 Point Fireplace Tune Up
- Check and clean pilot assembly
- Check igniter
- Test thermocouple/pile voltage
- Check and clean burners
- Limited blower cleaning
- Check current to the gas control valve
- Check for proper on/off switch and t-stat operation
- Check gas pressure
- Check for gas leaks
- Ensure proper safety switch operation
- Check vent for blockage
- Check for spillage at the flue
- Check and clean glass door and gaskets
- Check gas log condition (if applicable)
- Check remote control functionality
- Touch up firebox paint
- Replace ember bed material